Tightening the screws

• Tighten the Main screw without a torque wrench - Tighten the screw with 4 mm hex hey until the swing arm’s outer side aligns flush with the BASE unit’s outer side. The screw has reached or just exceeded 2.5 Nm at this point. Slight outward or inward alignment is acceptable. 
• When using a torque wrench - Tighten the Main screw to 2.5 Nm or up to 3 Nm for heavy loads (over 3 kg or 7 lb). 
• For all other screws, please refer to the specifications in the respective user guides.

* Do not apply grease on screws, threaded holes, or washers.

* Do not skip the metal washer on the 22mm long Main locking screw on the BASE Clamp.